logo fulling motor
hybrid stepper


Stepper motors are motion systems allowing to have a high positioning precision.With their high power already at low speed, their stall torque and the possibility to divide the steps in microsteps, stepper motors can provide direct and precise motions in a small volume.Permanent magnet and hybrid technologies are used to provide a full range of solutions.The absence of mechanical commutation gives to these motors a long life time which is usually given by the sleeves according to the load applied on the shaft.

brushless motor


A brushless DC motor (BLDC) is a synchronous electric motor which is powered by direct-current electricity (DC) and which has an electronically controlled commutation system, instead of a mechanical commutation system based on brushes. In such motors, current and torque, voltage and rpm are linearly related.



Often referred to as a “tin can” or“ can stack” motor the permanent magnet step motor is a low cost and low resolution type motor with typical step angles of 7.5 to 15° (48 – 24steps/revolution) PM motors as the name implies have permanent magnets added to the motor structure. The rotor no longer has teeth as with the VR motor. Instead the rotor is magnetized with alternating north and south poles situated in a straight line parallel to the rotor shaft. These magnetized rotor poles provide an increased magnetic flux intensity and because of this the PM motor exhibits improved torque characteristics when compared with the VR type.

ac servo motor


A Servo Motor is defined as an automatic device that uses an error-correction routine to correct its motion. The term servo can be applied to systems other than a Servo Motor; systems that use a feedback mechanism such as an encoder or other feedback device to control the motion parameters. Typically when the term servo is used it applies to a 'Servo Motor' but is also used as a general control term, meaning that a feedback loop is used to position an item.

special solutions

special solutions

Fulling Motor can develop all kinds of stepping motor, DC motor, AC motor, DC brushless driver, Mechanical Component to match customer demands. Our strong R/D team will be available for any special request. If you don't find what you are looking for in our catalog don't esitate to conatct us See here some of our Special Solutions.

news & events › NEW FACTORY OPENING



Dear Customer,

The new plant of Fulling Motor has been completed. The detailed address is #69 Kunlun Road, located in
the north of old factory, just 3 minutes’ drive. The area of new plant is 3 times larger than original one, up
to 18,000 square meters.
We decided to move to the new plant from June 30th, and our production produce and delivery will return
to normal since July 8th.
The move is a milestone in the history of Fulling Motor, because the old factory cannot meet the demand
of high speed development, in our new plant the production capacity can be increased by 50% in 2 years,
and in 5 years we planned to expand production capacity 2-3 times than original, which will greatly satisfy
the needs of customers.
In addition to maintaining the original mode of production and quality control, we Fulling also imported a
number of automatic production lines and lean production management concept, to improve production
efficiency and cost control.
Our company will be in accordance with the requirements of ISO and TS internal audit, also we required
TUV audit our new plant in this September to ensure the stability of our quality system. We have made a
careful move plan to ensure that the production process is just same as before, providing customers with
high quality products.
If you have any comments, please contact us.
YuFei Wang
General Manager